Show all posts by user
(RepRap en Français)
Page 4 of 4
Pages: 1234
Results 91 — 101 of 101
Thanks.
Ok i have tested with the last arduino 1.0.5 but nothing more ... It's the same ...
So for you when the display flash and buzz it's the right position of the cable ?
You haven't twist them ?
by
Steph ane
-
Delta Machines
Hello,
and if the LCD display blink and buzz (If you turn the encoder stop all and make a printer kill) ??
If I try to swap the cable the display is on but nothing on the screen ...
Have you any idea ?
(I use rambo board with adaptator...)
by
Steph ane
-
Delta Machines
Lechonquinto : perhaps it's interresting but i speak french and try to speak english so spanish not yet. but thanks
davew_tx :
no i don't spoke about jitter. My question was because on my firmware the servo go up and down for each point of the levelling.
In my case I use sevo for set 3 positions of my own machine (dual extruder) : 1 for extruder N°1, 1 for extruder N°2 and 1 for the probe.
And
by
Steph ane
-
General
Hello,
do you know if this type of code works ?
Because "previous_extruder" and "next_extruder" is implemented but if i'm right you cannot use conditionnal code (If ... Then -> End If) in the G-code like in CNC ?
I'm interesed by this fonction but for the moment I don't kow how to use for my own reprap ...
The best way will be have a custom G-code for engaged for each tool separatly in slic
by
Steph ane
-
Slic3r
I have found one part alone.
In "Marlin_main.cpp" tab. In auto leveling bed code (before G-Code programmation)
Near line 1055, I have comment the 2 line below
#ifdef SERVO_ENDSTOPS
//engage_z_probe(); // Engage Z Servo endstop if available // (Modif) enlève le fonctionnement servo pendant l'auto level
#endif //SERVO_ENDSTOPS
#ifdef SERVO_ENDSTOPS
//retract_z_probe(); // (Modif) enlè
by
Steph ane
-
General
Hello,
I use marlin with the autoleveling option and I occured some probleme with the servo movement between the point of the probing ...
Somebody know how to stop the servo movement between the different points ?
by
Steph ane
-
General
Perfect !!!
Work on my Rambo 1.1b.
I add only a picture if it can help somebody.
Thanks a lot for your post.
by
Steph ane
-
Controllers
Hello davew_tx,
i'm interseted too but my english is not so perfect (I'm french ... lol). Can you confirme the plug drawed on the picture of my board (Model 1.1b but it's about the same) ?
It will be great. Thanks a lot.
by
Steph ane
-
Controllers
Hello tkole.
I'm searching a solution too, for plug a servo on my Rambo 1.1b and implement the auto bed levelling ...
Do you have found something ?
by
Steph ane
-
RAMPS Electronics
Page 4 of 4
Pages: 1234