Show all posts by user
(RepRap en Français)
Re: Simplify3D - 11 years ago
Bonjour, Je viens d'acheter ce logiciel .... une merveille et des fonctionnalités vraiment intéressantes.by lolocaledo - RepRap Groupe d'Utilisateurs Francophone
Re: EEPROM parameters - 11 years ago
Thank you very much ggherbaz after checking, effectively jumpers for Z stepper driver is different. All jumpers for all other drivers and only 2 jumpers for Z axe driver. Do I have to change that ?by lolocaledo - General
Re: EEPROM parameters - 11 years ago
In the configuration.c I've downloaded, I have these parameters : #define DEFAULT_AXIS_STEPS_PER_UNIT {80,80,500*8,760*1.1} whenI send M501, I get these parameters : M92 X80.00 Y80.00 Z2013.30 E836.00 number of steps for Z and extruder are different !by lolocaledo - General
Re: EEPROM parameters - 11 years ago
Thank you for your answer. G code is something like M5xx, I remember to read something about that. So if I send M501, I get this following message : >>> M501 SENDING:M501 echotored settings retrieved echoteps per unit: echo: M92 X80.00 Y80.00 Z2013.30 E836.00 echo:Maximum feedrates (mm/s): echo: M203 X400.00 Y400.00 Z3.00 E20.00 echo:Maximum Acceleration (mm/s2): echo: M201 X7000 Y7by lolocaledo - General
EEPROM parameters - 11 years ago
Hello evebody, I'm new on this forum and it's my first post. I'm french and live in New Caledonia, in south pacific near the est of Australia. So could you be indulgent with my poor english ;-) I just bought my first used 3D printer, a G3D, similar to Prusa I3. So my question is : When one EEPROM parameter is define and written in EEPROM, wich parameter is considered ? EEPROM parameter or Marlby lolocaledo - General