Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Por definição a maioria dos fatiadores esquentam primeiro a mesa para depois aquecer o hotend, pois assim evita do hotend ficar vazando.
by
Dougwar
-
Brazil, São Paulo RUG
Hi, I'm trying to install a rgb led feedback in my print, but when the led goes white the lcd painel turn off and reset.
I'm using ramps 1.4, and pins 4, 5 and 6 no heatbead, transistor 2N2222.
My rgb led strip is 500mm long and about 0.4A
If I use a mosfet instead will it work?
Thanks
by
Dougwar
-
RAMPS Electronics
I have got the same trouble, when I connect the usb cable without the power supple the pronterface connect and show some information, like end stops open etc...
But when I connect on power supply and usb the pronterface doesn't connect, but only with the power supply I can control the print with the LCD control.
Any advice?
Thanks
by
Dougwar
-
RAMPS Electronics
Hi,
I'm trying to do a filament extruder and I get this;
too many bubbles in it, temperature were 190C, do you have any suggestion?
what's the dimension between the nozzle and the auger?
Thanks
by
Dougwar
-
Plastic Extruder Working Group