Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Thank you, Dust!
I suspect the short circuit may have damaged other parts of the board, though.
That's my suspicion, at least. Here's why:
The alternative circuit was buit (plan & circuit) and the firmware (Repetier) altered accordingly, it still doesn't work (temperature readings are constantly at 958°C / 1756°F)
Oddly, the voltage reading between any of the analogue pins and the GND pin
by
SteMega
-
Reprappers
First, I apologise for resurrecting such an old post, but I couldn't find a similar discussion in more recent threads.
I, too, short-circuited my microcontroller. I decided to follow Andrew Smith's suggestion but, since my knowledge on this subject isn't exactly outstanding, I have decided to ask a few questions before I proceed.
1. Resistor: Should I use something similar to the 1002 (10KΩ) in
by
SteMega
-
Reprappers
Boa tarde!
Li que, apesar de caro, é um material muito versátil.
Alguém já usou-o e tem alguma opinião? Sabe onde encontrá-lo no Brasil?
by
SteMega
-
Brazil, São Paulo RUG
