Show all posts by user
東京都 RepRap ユーザグループ
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
I'm using RAMPS 1.4 with Pololu-style controllers...hmmm, the steppers used to run a bit hot, but I turned down the amperage through the trimpots and made sure X and Y moved as smoothly as possible. I also have an 80mm fan blowing across the electronics. I'll look into this some more. I just came back after a trip and the first print had an x-shift very early on (I didn't even notice until som
by
daroldhiga
-
General
I have scanned the posts on this topic for an answer, maybe I missed it but let me give this a shot. I have a MendelMax, and most of the time it works great. I have a project that I'm printing for...so after about 16 hours straight or so the printer behavior starts deteriorating...eventually ending with X axis shifts. If I let it sit for a while, everything behaves as expected.
(MendelMax 1.0
by
daroldhiga
-
General
I will take you up on that at some point. I just ordered a bunch of parts, and I suspect I'll be knee deep and lost very soon...
by
daroldhiga
-
Japan, Tokyo RepRap User Group