Quotedavidf01 So when I order this E3D V6 do I need to add the Bowden add on I though I read that it has a Embedded bowden coupling. Not sure what that means? Thx If it's a real E3Dv6, and you order the bowden setup, it will come with bowden fitting press fit into the top of it. All you'll need to do is mount it on your effector and run your 4mm tube to it. Edit: If you follow the assembly iby Boxcar - Delta Machines
Hello. I've got a Folger Tech Mini Kossel Rev B sitting here along with a Smoothieboard. Does anyone have a smothieware config file for this printer that they could please share? I've tried searching the forum but I haven't had any luck so far.by Boxcar - Delta Machines
QuoteViper97 QuoteBoxcar Quoteflyway97 1. take off component D5 and F3; 2. Connect R-78E-5.0's 3 pins to the 3 solder joints as shown in the picture, (pin1 to label 1, pin2 to label 2, pin3 to label 3),then it can work well. Thank you! My MKS SBASE should show up in a week or so. I ordered a few R-78E5.0-1.0 from Digikey so I'll report back once I have everything setup. Post a how to for us oldby Boxcar - Controllers
Quoteflyway97 1. take off component D5 and F3; 2. Connect R-78E-5.0's 3 pins to the 3 solder joints as shown in the picture, (pin1 to label 1, pin2 to label 2, pin3 to label 3),then it can work well. Thank you! My MKS SBASE should show up in a week or so. I ordered a few R-78E5.0-1.0 from Digikey so I'll report back once I have everything setup.by Boxcar - Controllers
Quoteflyway97 innkeeper , frodriguez96 : change the DC-DC from L5970D to R-78E-5.0 can solve this problem on V1.0. arthurwolf : yes, DRV8825 and A4988 's radiating is on the chip bottom, so the best method to cool them is by the PCB, so we have carefuly deal with it on our PCB. But if the current up to 1.5a or higher, the temperature is also too high in spite of good PCB design. So adby Boxcar - Controllers
Both #1 and #2 look great. If I had to choose just one of them my vote would be for #1.by Boxcar - Reprappers