I want to use the RADDS 1.5 with Arduino Due and RADDS LCD only to control and fine tune the hotend of my CNC based printer. Can anyone tell me the quick way to use these electronics stand alone for this purpose? Which firmware settings are needed beyond heater, thermistor and fans?by wrreek - Controllers
The cable! :-/ that was it. How can I see this in advance? Thanks a lot it is working!by wrreek - Controllers
Yes I will do this. I dowloaded all in .zip and no errors uploading to Arduino.by wrreek - Controllers
Thx. I have this LCD and wiring is correct as I read from wiring diagrams. See attached photos.by wrreek - Controllers
I did but that didn't lead to anything showing on the screen. It just lights up and flickers a bit and beeps ticking sounds and no characters.by wrreek - Controllers
Thanks again! Still doensn't work. Is it repetier firmware 0.92.8 that makes troubles? In your uiconfig.h I see you chose a Type 5 (U8G supported display). Is this correct? shouldn't It be a Type 2 (4 bit LCD)? Do you have a RADDS 1.5 like me?by wrreek - Controllers
I have a RADDS 1.5 on Arduino Due and a RADDS LCD 4 x 20. I want to set it up with Repetier firmware but I cannot get it to work. It looks like the RADDS and Arduino are working well but the LCD doesn't. I need the right uiconfig.h and configuration.h settings. Can you help me. It cost me two days already. Can I use repetier firmware 0.92.8? Thanks a lot in advance.by wrreek - Controllers
Thanks for your reply. With the pot either way it doesn't change a thing. I think I don't have the correct uiconfig.h/configuration.h in my repetier firmware. Would you have a working example for me?by wrreek - Controllers
Please any help/tip or link to a source that I could not find yet?by wrreek - Controllers
I want to use a RADDS 1.5 and Arduino Due to control only the hot end temperature and the fans for cooling the print and for cooling the extruder. But somehow I don't get my RADDS LCD to show something. It only beeps a bit and the screen is flickering. Configuration: RADDS LCD display to RADDS with the red wires of the ribbons in the correct positions. RADDS 1.5 on regulated 24V 13.4A power supby wrreek - Controllers