What do i have to do to make this work with TMC2130 stepper drivers? i know how to hook it up, but seems like it might not be as easy as a few configuration changes/pin mapping... recompiling firmware isn't an issue if there needs to be changes.by mrwizzard - Controllers
I saw, it just wasn't labeled E0 but PWM3 which is weird. oh well, i'll give that a shot Thanks.by mrwizzard - Controllers
ok, while i got the thing to deploy, there is conflicting or lacking information on how to get the thing to trigger.... what am i plugging this into? all i see is E0 End stop, which is actually PWM 3 apparently but then instructions say use PW3 to deploy it. in any other firmware, marlin/repetier this is plugged into Z-Min. So what's it plugging into? Z-Min? Or PWM3 or analog pin 5 (proby mrwizzard - Controllers
Quotedc42 I've checked the pin mapping. Arduino Due pin 5 is P60 in the M42 and M280 commands, and pin 6 is P61. Thanks, that works i guess my pwm 3 don't work.by mrwizzard - Controllers
Quotedc42 What is PWM1 on the RADDS normally used to control? Not sure (i don't think the schematic is open source), but i had it on PWM1 with repetier, single extruder and PWM hotend fan and PWM cooling fan so it's not connected to those at least. PWM1 is on P5 (PC25 and PWM2 on P6 (PC24). I just set it in repetier config under servos. is there a way to switch it to PWM1? or do i haveby mrwizzard - Controllers
So i have a bltouch on PWM3 on the due/Radds, it was previously on PWM1 on repetier. it worked fine there. I did the usual config and disabled H3 via M307, set probe type to 4. However running the M228 P3 S10 I1 (or any variant) fails to deploy or do anything when sending gcode manually. unless it's a PWM3 issue at hardware level, is there any possibility of mis-configuration here? Cby mrwizzard - Controllers
I did manage to get it working FYI. probably was config since i just re-did everything.by mrwizzard - Controllers
Hey, Thanks for the reply. This was 1.18.1, didn't update it passed that. i switched back to repetier for now but planning on switching back using the latest version. i'll give that command a try if it happens again.by mrwizzard - Controllers
Just curious what you guys are using for SD cards that work with Radds on reprap firmware? only asking because i've loaded RRF on my due+radds and with the SD card, it resets the due over and over. if i remove the card while it's doing it, it boots and i can get the firmware info. if i remove the sys folder it also seems to boot but no configuration of course. So it seems to have issue withby mrwizzard - Controllers