OK, G0 seems to work...but seems to be software version dependent. Means there is some more to test... But next problem: the manual talks about referencing but not about the referencing pins. Only thing I can see is one (!!) limit switch per axis. So is this single pin used for all tasks, upper and lower limit as well as referencing? Or is there an other pin used for referencing which is not shoby Elm999 - Controllers
Hm, what I'm looking for ins neither a synchonised nor a sequential move, axes should be accessible independent from each other - but also should be able to move parallel...by Elm999 - Controllers
OK, but when I send this sequence, do the axes perform a parallel movement or do they work sequentially, means does axis Y wait until X has finished and Z until Y has finished its motion completely?by Elm999 - Controllers
"Galvo" is only halve of the story - a galvo needs some control loop electronics which keeps the galvo at a defined position. This control loop is somethign which definitely has to be done in hardware, you can't control this with a weak Arduino. So the question is, what data do your galvo controllers expect?by Elm999 - Controllers
Hi, I know about GRBL and similar Arduino firmware which does fancy CNC operations (means which have three axes X, Y and Z and user sends coordinate information to them in order to "draw" e.g. a line from the current coordinate position to the next one). What I'm looking for is much simpler, a possibility to control several stepper motor axes (preferredly out of an Arduino too) which are compleby Elm999 - Controllers