When I enter g1 x300 after homing all axis's an it only goes to 180mm in repetier host. I set my bed to be 456 on x and y.by usajet - General
After I do an x home on my 3d printer I can't move past +180. Which is happens to all axis. I want the axis's to go to the middle of the bed after I home all to the axis's. Am I doing something wrong? I am working with Marlin 1.1.0 RC7by usajet - General
I am trying to get this thing to work, Extrusion Concept I am working with Marlin 1.1.0 RC7. I type in T0 and I comes back with echo:Active Extruder: 0 but when I do the T1 command I get back echo:TInvalid extruder. I don't know if I have the right setup in my Marlin files. This is a custom 3D Printer built from scratch. I am using the MKS Base v1.5 board. I hav included my Marlin files. Thankby usajet - General
Need a little help. I have built an 3D printer from scratch and I need a little help with the firmware etc. I have the MKS Gen 1.4 board with the MKS tft32 LCD and the 12864 LCD(Not sure which one to go with) also I have the Bowden dual/quad extrusion extruder (single-nozzle single-drive). I need help with getting the servo to work for the Bowden dual/quad extrusion extruder (single-nozzle singleby usajet - General
It ended up being a clogged nozzle. Thank you for all your help.by usajet - Printing
How would I calculate it? Is there a calculator to use? Thank You!by usajet - Printing
Filament is set to 1.75 mm. What should the steps/mm be set at?by usajet - Printing
I am not at home right now so I will do my best. printing speed 60mm/s with PLA at 205 degree C. I have a parts cooling at 35%.by usajet - Printing
Any suggestions on what I should do? I have the right size of filament in the slicer. Thank you Nathanby usajet - Printing
I can on get the stepper motors on Z and X but only homing. I have adjusted the stepper driver 8825 to 0.7 dc volt on all axis. IS there anything I am missing? Do I have to hookup anything else in order for them to work?by usajet - Controllers
That worked. Thank Youby usajet - Controllers
I load the firmware files onto the SD card as instructed and it only shows booting and not updating on the screen. Please Helpby usajet - Controllers