Thank you David, it woks perfectly. I just had to raise the M570 P parameter over 45, to avoid the heating faliure. I understand completly why you drop the RADDS support, but I'm a bit disappointed becouse RADDS+DUE was a budget option to bring RepRap FW to low-end printers. Cheap deltas benefit the most from it. Do you plan to release cheaper (mini?) board? Like Azteeg X5 mini Wifi. I reallyby FTheta - Controllers
Hi David! I managed to melt down my bed connector on my RADDS board and probably damaged the FET too. The anoying thing is that the fuse remained unharmed and I used a thick, properly fastened cable. I managed to heat up the bed as a hotend tool on H2, through an external FET. Is there a way to configure the firmware to use the second heater pin as bed output to control the external FET? Gergby FTheta - Controllers