I have ramps board and got new TMC2208 divers fitted. I know I have fitted them correctly and set correct voltage. No further modifications just plugged in as is. Without making ‘any’ changes in marlin apart from inverting them the printer is working as expected. I’m not sure if that means I am getting any benefits from using them? If I change configuration file and state either Driver TMby Paul41 - Controllers
Thank you What I have found is using marlin there is a section to state TMC2208 drivers which if I enable gives me the issues on moving axis for X and Y but they will home correctly. If I remove section and don’t state TMC2208 drivers in standalone mode it works correctly. The thing is I am wanting the drivers to work in stand-alone mode So if in configuration file I state TMC2208 STANDALONEby Paul41 - Controllers
Hi I got the printer connected with Pronterface and check the end stops are triggered by using command M119. This all passed. Next I attempt to use X and Y arrows to move motors but nothing happens, I’m not even seeing a command being send or error codes. If I press the home X button the motors move and it correctly homes the X If I press the home Y button the motors move and it correctly homeby Paul41 - Controllers
When attempting to move X axis I can see code M105 is being sent but no movement. It states RECV ok T:-15.00 /0.00 B.0.00 /0.00by Paul41 - Controllers
Hi I got the printer connected with Pronterface and check the end stops are triggered by using command M119. This all passed. Next I attempt to use X and Y arrows to move motors but nothing happens, I’m not even seeing a command being send or error codes. If I press the home X button the motors move and it correctly homes the X If I press the home Y button the motors move and it correctly homby Paul41 - Controllers
Thank you for your reply, pronterface is my way forward! I will give that a try tomorrow.by Paul41 - Controllers
Hi I’m new to this forum and looking for advice on what next steps I can do to diagnose my current issue. Project: Quieten my CR10s further using TMC2208 stepper drivers. I purchased MKS Gen L version 1 board and MKS TFT 28” LCD. Wired everything together and set voltages on stepper drivers. CR10s has dual Z motors so used additional E1 port to connect this. Flashed Marlin by making apprby Paul41 - Controllers
Hi, I just joined this forum and noticed that you say there is a group that meet, that is something I would be interested in. I’m basically looking for some help on a modification I have madeby Paul41 - United Kingdom RepRap User Group