Hi there ..If you checkout my other posts you will find I was working on getting the Melzi controller board of my Tronxy 3D printer updated so I can install bed leveling. Well, I got the Melzi V2.05 board updated with the latest firmware..1.0.3 - machine type Meldel. I installed a bed leveling device on the side of the extruder..it is of type Auto Leveling Position Heated Bed Hotbed Sensor. I haby Richard_Brown - Controllers
Did you get your Melzi V2.05 controller board updated? What IDE did you use and what type of ISP programmer did you use? Thanksby Richard_Brown - Controllers
You know that did not update the EEProm... I will try to put a bootloader on it and see if that works. Note.. I tried that a while back and got the an error I then reduced the speed but did not try it.. Will let you know what happens. Thanks Also just to update you.. I am using the latest Arduino IDE to create a bootloader on the Melzi board. I have installed the USBasp drivers for the device I pby Richard_Brown - Controllers
Ok then is worked.... correct?????? I have two boards for my Tronxy 3S. I will install this one and test it.. NOTE: I have not put the bed leveling thing on yet. let you know what happens.by Richard_Brown - Controllers
OK let me do that .. getting late here.. will let you know what happens.. Thanks... Need more pictures.. let me know.. I am using the downloaded code from above thanks again. Richard OK I did that and did NOT choose the Upload using Programmer..... I just choose upload.. then I got this message.. Getting close..by Richard_Brown - Controllers
Dear Sir: I have that.. just is the picture did not turn out so good do I left it off.. But I do that that.. Do I need the USB cable plugged in also at the same time? Just plug in the special board with that connector and it should work Correct?? Thanks for getting back to me.. I will send some more pictures in a moment. NOTE some of these pictures are not so clear... let me know if you need moby Richard_Brown - Controllers
I have a Melzi board and a ICP Programmer to go with it. I have downloaded your firmware. I have Arduino 1.06 installed and the Sanguino boards installed. Yet it will not install any idea what i am doing wrong. Thanks Richardby Richard_Brown - Controllers