Show all posts by user
Anything related to printer controllers not being Duet, RAMPS or Sanguinololu: microprocessors, motor and heater driver circuitry, gEDA/KiCAD issues, soldering tips, etc.
How to install bootloader on MKS SGEN L V2.0 - 5 years ago
I have MKS SGEN L V2.0, its a 32 bit board and I accidently uploaded a 8 bit board (ATMega 2560) firmware directly to it using VS Code but then I realized my mistake while it was uploading so I pulled the USB cable and now its not being detected by Windows and shows error, "Device not Recognized." The LEDs light up fine, is there any fix? Here are few of my questions: 1. I don't see CH340G chiby ifleep - Controllers
Re: Please Help | MKS Gen L V2.0 Error Device Not Recognized - 5 years ago
Can flashing the bootloader resolve the issue maybe?by ifleep - Controllers
Re: Please Help | MKS Gen L V2.0 Error Device Not Recognized - 5 years ago
Thank you so much for your response. I tried removing the hardware and I tried the same drivers from Chinese site. I had installed fresh copy of Windows but I'm sure I did nothing that could fry the board Still it doesn't work.by ifleep - Controllers
Please Help | MKS Gen L V2.0 Error Device Not Recognized - 5 years ago
I have MKS Gen L V2.0 and when used for the first time, I installed CH340G drivers and it worked fine but one day I was trying to install firmware and I inserted the SD card with Marlin on it. I tried to connect it to PronterFace and it got connected, showed me the Marlin version and everything, but then I reconfigured the firmware and it did not work so I pulled my USB cord out of my laptop andby ifleep - Controllers