Show all posts by user
Anything related to printer controllers not being Duet, RAMPS or Sanguinololu: microprocessors, motor and heater driver circuitry, gEDA/KiCAD issues, soldering tips, etc.
Re: MKS Gen L problems. - 4 years ago
Here are the 2 config files from Marlin 2.0.9.3. The only thing I changed was to enable the heated bed.by Ianmark - Firmware - Marlin
MKS Gen L problems. - 4 years ago
I have a FLSUN i3 printer with an MKS Gen L v1 mainboard. I am at the end of my rope as I have been trying to get this printer running for over 2 months with no success. it had been running for 5 years without any issues, but I flashed it thinking it would work better. I have tried Marlin 1.0.x 1.1.x and 2.0.x. I have had board in the config.h file listed as both BOARD_MKS_GEN_L and BOARD_RAMPS_1by Ianmark - Firmware - Marlin
Re: MKS_GenL v1 issue - 4 years ago
I sliced something on a different slicer with different G-code and it was the same thing, so I presume it's in the config.h file somewhere.by Ianmark - Controllers
MKS_GenL v1 issue - 4 years ago
I have a FLSUN i3 with an MKS Gen L v1 mainboard. I flashed Marlin 1.1.9 and the printer seems be working well, except for one thing. The print head moves up about 1mm just before it lays down the filament. It moves up a few mm, then zero's itself. it then moves to print and at last moment, it raises a bit. This is my G-code. I looked in the config.h file, but don't really know what I should beby Ianmark - Controllers