Thank you for the hint! Bye, Gabrieleby lordgabriele - Laser Cutter Working Group
Yesterday evening I played a bit with the laser. At the moment I have connected the laser control wires to pin 25 and to ground. So I don't use yet your solution with EXXX command and stepper clock. The problem now is a strage behaviour of the laser. It should turn on for any G1/2/3 command and turn off for G0 command. Instead, it turns on correctly with G1/2/3, but if the Y coordinate is difby lordgabriele - Laser Cutter Working Group
Thank You! I Will check your solution in the evening! Gabrieleby lordgabriele - Laser Cutter Working Group
Hi, i'm trying to run a laser with Arduino DUE + RADDS as you. I have some problem to regulate the laser. How do you connect the laser to the board? Which command do you use to control it? By the way, i'm using repetier firmware. Thank you very much. Have a nice day, Gabriele.by lordgabriele - Laser Cutter Working Group
Anche io non lo sapevo!! :Oby lordgabriele - GCODE, Software e Firmware
La cosa che mi aveva colpito di più all'epoca del cambio sono stati i tempi di processamento: adesso non so se le cose son cambiate... ma ricordo di aver dato in pasto a slic3r un modello molto complesso e ci ha messo un tempo nell'ordine delle decine di minuti, simplify3D era invece nell'ordine dei secondi! Inoltre ho trovato molto ben fatta la gestione dei supporti. Li genera automaticamente ilby lordgabriele - GCODE, Software e Firmware
magari sto dicendo una fesseria, ma lo spurgo non potrebbe essere fatto da più colonne? una per colore diciamo...by lordgabriele - Discussioni generali - NO PROBLEMI DELLA STAMPANTE
So che costa un pacco di soldi, ma ho comprato Simplify3D e se potessi tornare indietro lo ricomprerei assolutamente!! Prima dell'acquisto usavo Slic3r... Un'altro pianeta!!by lordgabriele - GCODE, Software e Firmware
Io mi sto organizzando per aggiungere alla mia stampante un oggetto come quello che puoi vedere nel link... non ti posso dare ulteriori info perchè non sono ancora entrato nel vivo, sono ancora alla fase preparatoria Filament Splitter Spero possa darti un'idea ulteriore!!by lordgabriele - Discussioni generali - NO PROBLEMI DELLA STAMPANTE
Fatto!! Come Paso la mia stampante l'ho progettata e costruita, per cui alcune domande mi son state un po' strette, ma ho cercato comunque di rispondere meglio che ho potuto In bocca al lupo, Gabriby lordgabriele - Discussioni generali - NO PROBLEMI DELLA STAMPANTE
Dear Angelo, i want to buy a RADDS v1.5 board, but every e-shop that i visited is OUT-OF-STOCK. Please, can you tell me where i can buy a board or when it will be re distribuited to the popular shops? By the way, I'm from Italy. Thank you very much. Best regards, Gabriele.by lordgabriele - Wanted