Show all posts by user
http://reprap.org/wiki/Laser_Cutter
Re: G Code Sender for Ramps 1.4 - 1 year ago
Your thoughts seem a bit difficult I'm researching other programs. Thanks a lot.by mrtcnblgc - Firmware - experimental, borrowed, and future
Re: G Code Sender for Ramps 1.4 - 1 year ago
How can you configure Pronterface? Can I use other slicer programs like Cura?by mrtcnblgc - Firmware - experimental, borrowed, and future
G Code Sender for Ramps 1.4 - 1 year ago
Hi everyone. I Have struggled about g code sender software. I made a laser cnc machine with arduino and ramps 1.4. I'm using marlin firmware. I used Lightburn but the trial period has expired. I'm looking for a new software like Lightburn but free . Can anyone help me?by mrtcnblgc - Firmware - experimental, borrowed, and future
Re: About Two Trees DB5500s Laser Module - 1 year ago
Thanks for advices. I try a fan like air assists. But nothing change. I think my MDF is very strong. I try 3mm black acyrilic and results is good. Yes 40W is electrical power but ı measure the amper of laser diode and 1.67A in %100 power. So its power 12V*1,67A = 20 W. I wonder if this is 24V? Because its driver boards pins are -12V and +12V. Not GND, +12V.by mrtcnblgc - Laser Cutter Working Group
About Two Trees DB5500s Laser Module - 1 year ago
Hi guys, I have build my DIY Laser Engraver with Ramps 1.4, and I bought a 40W Laser Module link I use marlin firmware. I open LASER_SYNCHRONOUS_M106_M107 and SPINDLE_LASER_FREQUENCY 1000. I use D9 pin for laser output on ramps card. PWM, +12V and Fan+ pins are connect the D9+ , -12 and FAN- pins are connect the D9- And in Lightburn software ı use M106/107 and M03/M05 commands both But Iby mrtcnblgc - Laser Cutter Working Group