Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
Solved my problem, I'll try to keep the post short.
I was able to get Sprinter running through ReplicatorG still can't get RepSnapper or the standard RepRap host to connect (it might be a Windows Vista issue). Any way ReplicatorG was able to run the extruder so I knew my driver and pins were correct.
Next I did some digging (not sure why I didn't find it earlier) Repetier has a minimum extrusio
by
M.Kots
-
Canada Waterloo RUG
I can't get my extruder to move. I pass the extrude code to the board and the extruder just hums.
- I have Ramps 1.4
- I have swaped the E0 & E1 due to a poorly placed heat sink on the sheild (I have switched the pin.h file also)
- X,Y,&Z work as they should (E works when plugged into one of them)
- Pololu works when plugged into X socket
- Using Repetier firmware & host because spri
by
M.Kots
-
Canada Waterloo RUG
Hey where is everyone getting their filament? I picked some up from makerbot.ca it showed up fast and I don't have to pay duty but they only have ABS, it's coming from Saskatoon and currently they are out of stock of white and black (probably the more practical colours). Just curious.
Thanks
Mark
by
M.Kots
-
Canada Waterloo RUG
Hey Andrew,
I'm not sure if you are still tracking down parts but I got a set from . They are located in St. Catherines and the parts looked great. They cleaned the parts and it looks like the holes too (I am still waiting for my hardware before I will know for sure). I got the complete set at my mailbox in less then a week. They have been very helpful already, much more then the people I tried
by
M.Kots
-
Canada Waterloo RUG
