I seem to have the same issue and I've had a similar experience with their support For me, the symptoms are extruder motor skipping unless I turn the feed rate to very low. When I switched from pancake to full sized motor the gears would skip. It would help if you would post some photos of the original and the TriangleLab clone. Even the ones you sent to TL support would helpful. I've attachedby Brilliant name - Mechanics
QuoteRoberts_Clif I find that I have to enable the Bed Leveling in the Slicer like so M420 S1 ; Bed Leveling on. these are the last 3 line in my slicers startup G-Code. G92 E0 ;reset extruder length M420 S1 ; Bed Leveling On M220 S32.000000 If I do not enable the Bed leveling data I also crash into the Bed on occasions. Yes, I have. I forgot to write it in the OP.by Brilliant name - Firmware - Marlin
Hi! Using an Ender 3 with a warped bed, so I got the TH3D firmware to get mesh bed leveling. I first do corner leveling, test print, repeat until good. Then I do 5x5 mesh level procedure, store the data, check with M420 V1. Enable bed leveling from the LCD. Start corner leveling and my corners are off (I don't touch the adjustment knobs)? Disable bed leveling. Enter corner leveling, my corners aby Brilliant name - Firmware - Marlin