Show all posts by user

Problems to compile sprinter under Ubuntu 11.10 - 14 years ago

Hi there, I cannot compile Sprinter firmware after upgrade from Ubuntu 10.x to 11.10. Before upgrade all was OK, but now if I run "Verify" command (the play button) in the Arduino 022 or 018 (I tested both), after while it says Error compiling and writes down in the black window: In file included from /usr/lib/gcc/avr/4.5.3/../../../avr/include/util/delay.h:44:0, from /usr/lib/g

by serych - Firmware - mainstream and related support

Start and End code examples - 14 years ago

Hi there! I'm newbie in RepRap and G-code. My (Mendel-Prusa/Wade) printer started to produce first printouts which are not perfectly tuned-up, but usable Now I would like to write/modify some start and end G-codes for Skeinforge. It would be nice to reset E value in the begining in the startcode. I'm trying to print without the raft module and that's why I would like to print some kind of "lea

by serych - Skeinforge

Re: Sanguinololu - board commisioning - 14 years ago

Problem solved Source of the problems was, that I'm using atmega644 and not 644P procesor. When I tried to compile Sprint firmware, all seemed to be OK, but in the moment I tried to upload it to the board, avrdude told, that the signature of the chip doesn't response to the compiled file and it didn't upload anything. So I tried to edit atmega644P (or atmega644p) strings in Sprint Makefile, co

by serych - Sanguino(lolu)

Sanguinololu - board commisioning - 14 years ago

I have soldered Sanguinololu ver: 1.3a, programmed bootloader and it seems that succesfully programmed Sprint firmware using USB to atmega644 (I'm using 644 not 644P). When I connect the board (without Pololus and any other devices (thermistors and endstops) connected), in pronterface, it writes: start Printer is now online SD init fail but it seems, that the board ignores any other commands.

by serych - Sanguino(lolu)

Re: Prusa - belts - 15 years ago

Thx Jakub

by serych - General Mendel Topics

Prusa - belts - 15 years ago

Hi everybody, I'm building my first RepRap - Prusa, and I'm not sure which belts are pulleys designet for. I have found company which sells belts, but they have types T5 and AT5. The AT5 belt has a bit longer teeth with shorter round shaped spaces in oposite to T5 profile, which has aproximately 1:1 ratio tooth:space and teeth are more rectangular (both belts have the right 5 mm pitch). When I

by serych - General Mendel Topics