Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
This is the approach I am working on,
here is a link to the thingiverse project.
This is still work in progress.
by
dmserve
-
Reprappers
Are you also disconnecting the 12vdc?
I have had Pronterface will act the way you are describing too.
This works for me.
Shutting down
1 Shutdown Pronterface
2 Disconnect 12vdc.
3 Disconnect USB
4 Wait for the Red LED to go out
Startup
1 Connect 12vdc.
2 Connect USB
3 Start Pronterface
4 Connect
Varying from start up order, results in Pronterface connection failure for me.
Not waiting for LED
by
dmserve
-
Reprappers
Set up your Com port in device manager first.
(recommend 4 or higher)
_________
Open Arduino
Click on in the upper menu
hover over
the available com ports will appear to next to it
move over the one you want, and click on it
You can click on in the upper menu again to see if was properly selected.
_________
Then select the same com port in Pronterface.
Select Connect.
_________
If Pronterfa
by
dmserve
-
Reprappers
Are you in control of the motors or are they moving back and forth?
To fix your connecting problem:
Try changing from com 3. Some computers reserve com 1-3 for other uses.
Change to com 4 or above (I use com 9)
Set your baud rate in the computer @ 150000 (device manager)
Set Arduino @ 250000
Set Pronterface @ 250000
This are the numbers that work for me.
by
dmserve
-
Reprappers
Wavemill,
I am getting the same error.
Error:
: Extruder switched off. MINTEMP triggered !
Error: Printer halted. kill() called !!
In Marlin you can edit CONFIGURATION_H
Find this area and change # 6 to 0
Original:
#define TEMP_SENSOR_0 6 // Extruder
#define TEMP_SENSOR_1 0
#define TEMP_SENSOR_2 0
#define TEMP_SENSOR_BED 6 // Hot Bed
I can make this change and able to move all axis, load a
by
dmserve
-
Firmware - mainstream and related support