Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
Quotepras_pune
I am currently looking into defining a fifth axis parameter 'Q' so I can print simultaneously using: G1 X-- Y-- E-- Q-- etc. Though I am stuck with several errors in the firmware as I am trying to update.
Also, checkout the M160 code for multiple mixed material printing: . Maybe this helps. And were you able to figure out how to use E0 & E1 to print simultaneously?
We had a c
by
GoSharks
-
Firmware - mainstream and related support
We are looking to extrude using two extruders simultaneously. As far as I can tell, the stock Marlin firmware does not allow for this and instead requires one to switch extruders using T0/T1. Does anybody have experience either modifying the firmware such that we can independently control the E0 and E1 outputs at the same time, or know of a different firmware that will allow for that.
Alternativ
by
GoSharks
-
Firmware - mainstream and related support
Turns out that I needed to specify a feedrate in my gcode command.
by
GoSharks
-
RAMPS Electronics
I'm a relative beginner at this, so forgive me if I'm missing something extremely obvious. I have a RAMPS 1.4 with a slightly modified Marlin firmware. The modifications were to disable the temperature sensors and to enable the second extruder driver.
I have run into the following problem while testing with Pronterface:
When I send a "G1 E1" or "G1 X1 E1" command, all the motors move as expected
by
GoSharks
-
RAMPS Electronics