Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 6 of 6
I have tried all sorts of fast ways to smooth my prints. Sanding words great but is time consuming, what do you all use? this is the vid I made on how I do it
by
mgooch
-
Polymer Working Group
I have an 8gp scandisk ultra, and it works fine in one of my ramps but not in others, also have 4gb scandisk that doesnot work anywhere, had a 512mb that rarely works, is there a certain brand that works better or what all I have is scandisk... ramps 1.4 marlin 1
by
mgooch
-
Firmware - mainstream and related support
Thanks so much I put the three jumpers in and presto they work also was able to calibrate my steps per unit easily using the link that paul provided , now im off to see how well my hollow cube comes out
by
mgooch
-
Reprappers
if it would help to see a video I could upload one
by
mgooch
-
Reprappers
thanks Paul, I am running repetier-Host c0.95f and firmware marlin v1 sprintermashup for gen 6(not sure what that last one is and compatability to ramps 1.4.) the motors that i have are minebea 1.8degree, I have none of the microstepping jumpers in, should I? the link to the specification of my motors is here so can I damage my motors or boards by over or under adjusting
by
mgooch
-
Reprappers
I have a strange problem going on, I couldn't find a thread specifically about this. When I run my test code in ramps 1.4 my motors move fine, very fast acually all hooked up. however when I actualy load firmware(marlin v1 via arduino 0022) and interface (tried pronter and repetier with more succes with the latter)I am having trouble getting them to move the way they should. the seem to move for
by
mgooch
-
Reprappers