Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
David, That did it, at least it said done downloading with no errors. The red debug light is blinking on the motherboard I hope that is OK! I'll try testing it and see. Thanks much
Monty
by
montyram
-
Firmware - mainstream and related support
David, where do you change the programmer from stk500 to ardunio?
Markus, the port is free, the board is Sanguino, the port is /dev/ttyUSB0, and I have unplugged the USB and waited - used the reset in all different timing modes and still get the same error. The first thing I did was upload the bootloader with usbtinyisp and that did fine. I upload the bootloader and uploaded the extruder progra
by
montyram
-
Firmware - mainstream and related support
I am running Xubuntu 10.04 Kernel Linux 2.6.32-23
Basic RepRap bootloaded with usbtinyisp said ok
I built my own motherboard.
When I upload FiveD_GCode_interpreter Arduino says "Problem uploading to board."
and in the window
"Binary sketch size: 20954 bytes (of a 63488 byte maximum)"
"avrdude: stk500_recv(): programmer is not responding"
I have used the reset button before, after, etc same thi
by
montyram
-
Firmware - mainstream and related support