Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Usually, i work with ramps 1.4 and marlin for prototyping and experimenting, but can use also other firmware.
I will check in the code, must be not difficult to adapt if is not possible just by configuration and i post here results
by
Natsu
-
Firmware - mainstream and related support
I wonder if is possible with some firmware using 2 end stop's on separate Z motor (aka Z_DUAL_ENDSTOPS in Marlin FW) for G28 and using a sensor (inductive or whatever) con extruder block when using G29.
If some one already did that can just share the info or a link.
(I prefer to ask before change some code)
Tyvm
by
Natsu
-
Firmware - mainstream and related support