Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Hi Roberts-Clif, thanks for your reply,
I tried to remove the potentiometer with a soldering iron but it's really too small for me. It doesn't melt and I don't want to heat to much.
About the first option :
Here is the code that I want to modify : Here
I think it's in the section pins.h but I can't find where to swap pins
/*********************************************************************
by
monstertom
-
Firmware - mainstream and related support
Oh and by the way, I have a new problem, i can't send my sketch in the minitronic board. It worked fine before.
I got this message : 0xff != 0x0c avrdude: verification error; content mismatch
I use Arduino v 1.6.3 from reprap world website.
Does someone have a solution for me?
Thanks
by
monstertom
-
Firmware - mainstream and related support
Hi there,
I need your help to solve my problem. I'm a newbie about 3d printing and I'm trying to mount a Foldarap.
I have some issues with the x axis controller (I broke the tiny potentiometer) and I can't use it anymore...
My Idea is to wire two Z stepper in parallel on Z axis controller and plug my X stepper on the old Z2 controller.
Is it a good solution? How should I switch pins in Marli
by
monstertom
-
Firmware - mainstream and related support