Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
MKS Gen L uses pins_RAMPS.h to define pins. I switched them around. Didn't solve my problem but I did figure it out.
by
deathguppie
-
Firmware - Marlin
Stats:
mks gen L v1.2 running 24v using 100k 3950 thermistors on both hotend and heatbed. Running marlin 1.1.9 firmware. PID is generated using m303 command.
Heat bed is working fine. I've used a handheld infrared sensor to check the temp on it and have good temperature readings both on the current 24v and the previous 12v.
Infrared sensor can't get a reading off the hotend as the area is t
by
deathguppie
-
Firmware - Marlin
I have marlin 1.1 installed on the board no problem. So maybe I don't need 2.0 but I'm getting an auto leveling sensor probe today that I want to try to make work, and something I read made me think I might want 2.0.
So it errors on LPC1768 environment. Which I do not have set as my environment. Aside from just not being able to find it, LPC1768 is for an Cortex-M3 LPC 1768 main chip, which m
by
deathguppie
-
Firmware - mainstream and related support