Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Thank you for your response (aswell on the other topic).
I'm planning on only using the board to drive stepper motors for a robot arm I'm designing.
by
RobinBonl
-
RAMPS Electronics
Dear all,
I want power a Ranps 1.4 board with 24V. I read that I have to remove the D1 diode, check all capacitor ratings and replace the fuses.
In my case, I only want to drive the stepper motor's with the ramps board (no heating bed). I saw there was a 30V fuse connected to the 5A line and a 16V connected to the 11A line. If I were to remove the D1 diode and only use the stepper motor 5A powe
by
RobinBonl
-
RAMPS Electronics
Dear all,
I'm trying to upload a simple arduino sketch to my mks gen L V2 board. When the compiling is done I get an error after a while. I do not know what is causing this issue. I have checked a few things:
- correct cable
- update CH340 drivers
- correct COM port (it disappears after unplugging)
- Arduino Mega board and processor selected
- hold reset button when uploading or pressing it once
by
RobinBonl
-
Firmware - mainstream and related support
