Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
repetier Wrote:
>
> @ninja0n3 Have you tried disabling VBOs in the
> 3d-settings? I remember you had the same problem
> with the earlier version or do you see the model
> in the composer this time? Then look id
> 3d-Settings if the Radio button left from Layer
> Height is selected.
>
I can see the model(s) in the STL composer with no problems (same in 0.26) but for some
by
ninja0n3
-
Firmware - experimental, borrowed, and future
Hello,
I've compiled the source files for 0.28. Very nice update.
I seem to have some troubles with the Job pane: the job pane model does not appear for some reason (I did Alt-3 and clicked on the eye button with no success).
Any ideas?
by
ninja0n3
-
Firmware - experimental, borrowed, and future
Bought my Prusa full kit (plastic parts not included) which included all mechanical and electronics. Best value for Canadian buyers.
Shipping was delayed due to backorder, fairly smooth transaction.
A couple of screws and bolts were missing, still waiting for those.
by
ninja0n3
-
General
Hello,
I just finished my Prusa build and I am about done with the electronics.
As I was testing things out, I ran into the following problem:
My extruder stepper, jerks to one side then stops moving (although the motor is still powered as it shows resistance when trying to turn it by hand).
My setup is RAMPS 1.4 with Arduino Mega 2650.
The firmware I am using is repetier-firmware (for which I
by
ninja0n3
-
General