Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
So I have been looking into this further.
I am using an Arduino Nano V3 as the control board, which is working just fine with any other program that I use (ie non Teacup).
I have taken the latest Teacup (as of 23/07/13) and compiled using the Arduino environment. I use Repetier host to send G-Code (Any other recommendations?)
Also compiled on linux, with no change.
I have tried several dif
by
totalis
-
Firmware - experimental, borrowed, and future
Im on a windows 7 machine, with win-AVR installed (20100110)
Downloaded the latest version of the Teacup firmware
Open with arduino 1.0.5
dda_lookahead.c: In function 'dda_join_moves':
dda_lookahead.c:214: error: 'for' loop initial declaration used outside C99 mode
dda_lookahead.c:455: error: redefinition of 'sreg_save'
dda_lookahead.c:214: error: previous definition of 'sreg_save' was here
d
by
totalis
-
Firmware - experimental, borrowed, and future
Hi all,
For several months I have run my reprap mendel on Teacup firmware. I love it! I use Repetier host to send the G-Code to the machine, which has never been a problem on my laptop at all.
I also own a desktop, and so I wanted to leave the reprap plugged into the desktop, so i could still use my laptop when needed.
I downloaded the same version of Repetier host onto my desktop and tried
by
totalis
-
Firmware - experimental, borrowed, and future