Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Hi everyone,
I am a beginner with building 3D printers. I have just completed building a Mini Kossel delta printer as well as an Ultimaker. I am using RAMPS 1.4 boards on Arduino Mega 256. For both, instead of using an extrusion system, I am using a valve that pushes out pressurized material controlled by the microcontroller. The valve is pre-programmed. All it needs is 5 volts to open and it do
by
piscosour00
-
Firmware - experimental, borrowed, and future
Thank you, Traumflug!
I will repost this question into that subforum.
by
piscosour00
-
Developers
Hi everyone,
This is my first post. I hope I am posting this question in the right forum.
I have just completed building a Mini Kossel delta printer as well as an Ultimaker. I am using RAMPS 1.4 boards on Arduino Mega 256. For both, instead of using an extrusion system, I am using a valve that pushes out pressurized material controlled by the microcontroller. The valve is pre-programmed. All it
by
piscosour00
-
Developers