Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Hello all,
so finally I have found my problem source - it was thermistor wiring, cable was broken from bending by carriage movement :-(
I will upgrade my Marlin release too, the only problem is, that somebody already programmed code for run of filament detection, which I already have for a long time, so I will need to compare both new and my old code to rewrite my function into new version.
Reg
by
Smart
-
Firmware - experimental, borrowed, and future
Hello all,
thanks for your answers! My printer have Graphical RepRapDiscount LCD.
What type of printer do you mean dc42? It is based on open-source project, but mime and friends built: www.poseidon3d.cz
Idea with "the same spot on the bed" looks great, I will check it - thanks!
I have checked all thermistor connectios and it looks OK. I will check it once again with heating block too and give a
by
Smart
-
Firmware - experimental, borrowed, and future
Hello RepRapers,
I am testing latest released Marlin FW 1.0.2 in my 3D printer. My printer is monitored by OctoPrint, but I always print from SD card. Today, I spotted strange behaviour of my nozzle temperature - when there was a lot of small moves (high resolution cirle, etc.) the temperature felt down from 230°C to 170°C on OctoPrint graph. There was "Cold extrusion prevented" in serial log too
by
Smart
-
Firmware - experimental, borrowed, and future
