Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 10 of 10
where is the test build? the one i find in your github is from 22/06, is that one?
I have this 2000+ degrees bug from time to time
thanks,
EDIT: flashed and has no sensorless support
I go back to previous version.
by
ESTIMULO
-
Firmware - experimental, borrowed, and future
Hello,
I can't make it work sensorless, it doesn't stop.
SKR 1.3 with jumpers for sensorless in X and Y.
M122 (drivers section):
Error status: 0
Driver 0: standstill, SG min/max 94/94, error r/w 0/1, ifcnt 138, cnt r/w 1489/13, timeout 0, failedOp 0xff
Driver 1: standstill, SG min/max 238/238, error r/w 0/1, ifcnt 152, cnt r/w 1489/13, timeout 0, failedOp 0xff
Driver 2: standstill, SG min/max
by
ESTIMULO
-
Firmware - experimental, borrowed, and future
Thanks, I will flash it this night at home.
I am running in a skr 1.3 + 4 tmc2209 + 1 lv8729.
Can you show your config to see sensorless part as a start point to tune?
thanks again
by
ESTIMULO
-
Firmware - experimental, borrowed, and future
Quotegloomyandy
On the ADC changes one problem I see from time to time with my printer is that after a reboot some of the temperature readings are completely wrong (probably some sort of full scale reading), but it only happens very infrequently and a reboot of the board seems to fix it. I've never been able to pin down what is going on. Have you ever seen this?
I am working two days (in short p
by
ESTIMULO
-
Firmware - experimental, borrowed, and future
hello, is it possible to mount it in an effector like this one?
I would like to mount it on a delta printer with bowden.
Thanks!!
by
ESTIMULO
-
General
thanks Origamib, I will try 40mm version!
by
ESTIMULO
-
General
Please, can you share those stl for 40mm blower? thanks in advance!!!
by
ESTIMULO
-
General