Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
It is purely a guess on my part Deafboxer but are you using the correct serial device in your config?
ie in the example config for generic-ramps
serial: /dev/ttyACM0
pin_map: arduino
by
crow
-
Firmware - experimental, borrowed, and future
Quotemdm63
Hi!
I had quick look at Octoprint plugin tutorial, so how hard can it be? I will take a crack at it, as it seems to me that plugin would be best option to make configuring klipper user friendly. I am simply thinking a tab in octoprint settings menu to setup the printer.cfg with some simple fields and explanations/help texts to go with them. I have finally some free time next week, so
by
crow
-
Firmware - experimental, borrowed, and future
just hooked up a thermistor to the BBB/Replicape
Recv: ok T0:19.7 /0.0
Send: M105
Recv: ok T0:26.7 /0.0
Send: M105
Recv: ok T0:32.6 /0.0
Send: M105
Recv: ok T0:33.5 /0.0
Send: M105
Recv: ok T0:33.9 /0.0
Send: M105
Recv: ok T0:33.6 /0.0
Send: M105
Recv: ok T0:29.6 /0.0
Send: M105
Recv: ok T0:27.0 /0.0
Send: M105
Recv: ok T0:25.0 /0.0
Send: M105
Recv: ok T0:23.8 /0.0
Send: M105
Recv: ok T0:22.8 /0.
by
crow
-
Firmware - experimental, borrowed, and future
I installed today on the BBB/Replicape and installation went well.
I could not find serial port in Octoprint and found I had to change to this in the config and it worked after that
serial: /dev/rpmsg_pru30
Endstops seem to do as expected when using the M119 command in the terminal in Octoprint
I will check thermistors tomorrow then it will need the TMC2100 stepper driver support to check step
by
crow
-
Firmware - experimental, borrowed, and future
Hi Kevin,
I really like your concept of printer firmware and congratulations on your work.
Do you have plans of porting to Beaglebone Black?
I have a BBB with Replicape that uses Redeem firmware and I would like to use your firmware.
The Replicape and Beaglebone Black I think is a good combination and your firmware I think will improve it even more.
Do you have plans of implementing a autocal l
by
crow
-
Firmware - experimental, borrowed, and future
Hi Kevin,
I really like your concept of printer firmware and congratulations on your work.
Do you have plans of porting to Beaglebone Black?
I have a BBB with Replicape that uses Redeem firmware and I would like to use your firmware.
The Replicape and Beaglebone Black I think is a good combination and your firmware I think will improve it even more.
by
crow
-
Firmware - experimental, borrowed, and future