Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 6 of 6
I drive first "Z" home. "Z" is open. Then I drive "Y" home. Then I try to send M119, but there is no answer. I disconnect the connection and restore it. Then I send M119 and get this message:
X_min: open y_min: triggered z_max: open.
On my video is to see how it reaches "Y" end stops and stops. Unfortunately, it does not react anymore and only buzzes loudly. If the end stops were not, the carria
by
Dj EKI
-
Firmware - experimental, borrowed, and future
I have now noticed that the old setting no longer matches the new one. Now the motors have to be inverted.
I've changed the now.
#define ENDSTOP_CLEARANCE_X 4000
#define ENDSTOP_CLEARANCE_Y 4000
#define ENDSTOP_CLEARANCE_Z 4000
This time I added a video so you know what's going on. As I said, the old firmware worked great.
Ich habe jetzt bemerkt, dass die alte Einstellung nicht mehr mit der ne
by
Dj EKI
-
Firmware - experimental, borrowed, and future
sorry for the late answer. What could be the cause of the motors buzzing out when the end stops are reached? It is then only a continuous tone to hear from the engines. My end stops are Optical and with PullUp.The old firmware worked very well, only the new one no longer.
Wenn du Deutsch reden kannst, würde ich gerne so mit dir weiter reden
by
Dj EKI
-
Firmware - experimental, borrowed, and future
I still had a very old version and it worked perfectly. Unfortunately I changed something on the code and it does not work anymore. So I downloaded the new Teacup.
If I press X Home, then it goes to the end stop, but it then buzzes loudly and it no longer responds.
With Y happens the same. I can only reset my Arduino Uno.
Z works. I can give further commands, but with X and Y it does not work. Z
by
Dj EKI
-
Firmware - experimental, borrowed, and future