Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
Seems I have found some kind of non-critical bug in Marlin firmware.
And when play around this bug I see some strange behavior of current position shown by Repetier Host. It seems to mee that it is bug too.
To reproduce it you can move the head in the middle of your table, power on your printer and move head to some position over endstop, say with g-code like G1 X500
The head shoud move to ends
by
evgen
-
Repetier
Hi,
I work with Marlin 2.0 bugfix on lpc1768 and found some strange behavior of enstops.
Axis X with two endstops. Let's say, Initial position 0, endstops are at -5.0 and +5.0
Home not found.
//Endstop Settings
#define USE_XMIN_PLUG
#define USE_XMAX_PLUG
// Travel limits (mm) after homing, corresponding to endstop positions.
#define X_MIN_POS 0
#define X_MAX_POS 250
//#define MIN_SOFTWARE
by
evgen
-
Firmware - experimental, borrowed, and future