Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
Quotegloomyandy
What are you doing to set stealthchop and how are you determining what mode they are in?
The same printer running Marlin 2.0 runs completely silently. Perhaps the default settings in Marlin are configured more correctly. Can you compare the 2208 default settings from Marlin with the settings in RepRap?
by
SilentStorm
-
Firmware - experimental, borrowed, and future
QuotegloomyandyI have just updated my build (that does have support for TMC22XX devices in UART mode) and if you would like to try it you can grab the binary here:
Note that this is built for WiFi not ethernet.
I just tested on an SKR 1.4 board with 2208 XYZ and 2209 E drivers.
UART OK
Set microstepping OK
Set current OK
Set interpolation OK
Set stealthchop mode - Not working.
by
SilentStorm
-
Firmware - experimental, borrowed, and future
Quotesdavi
Binary for 3.01RC1 is now available:
I have also updated the LPC config tool (I didn't spend much time on it so it might be a bit buggy, only has a few boards and it's now a bit behind the official version). This version will generate a board.txt.
Please add SKR 1.4 to the configurator. Pin names do not match SKR 1.3
by
SilentStorm
-
Firmware - experimental, borrowed, and future