Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Quotejay_s
The "I" command is no longer supported in RRF3
This is an extract from the duet wiki for M558
Invert the input by prefixing the input pin (C parameter) with ! character, when using an NPN output inductive or capacitive sensor or using an NO switch (not recommended, use a NC switch instead).
@jay_s: You are my hero dude. I was not able to find this info inside the reprap.org/wiki
by
jafido
-
Firmware - experimental, borrowed, and future
ok I am back with another question to the Z-probe.
I am using Precision Piezo Orion v2.0 connected over the digital output to the zmin on the SKR v1.3
Quote; Endstops
M574 X2 S1 P"xstopmax" ; configure active-high endstop for high end on X via pin xstopmax
M574 Y2 S1 P"ystopmax" ; configure active-high endstop for high end on Y v
by
jafido
-
Firmware - experimental, borrowed, and future
thanks again Jay_s,
there was nothing but after few restarts the change was propagated. . This firmware is like from another world. It is completely different philosophy in comparison to the Marlin. Is there any chance that somebody has already designed the PCB for SBC and SKR v1.3/1.4? I wanna build some and it is a question whether to design it from the scratch or somebody has already made it.
by
jafido
-
Firmware - experimental, borrowed, and future
thanks jay_s,
I haven't got from description "The first example informs the firmware that bed heater 0 (implied, because no P parameter is provided) uses heater 0." that M140 H0 command does the trick . My learning curve to be familiar with the RRF is not so steep as I would expect from youtube videos.
I've modified the config.g according to your suggestions but I am still not able to display
by
jafido
-
Firmware - experimental, borrowed, and future
Hello together,
I've just joined the club with RRF 3.1.1-6 running on the SKR 1.3 and 5x TMC2209 connected to Raspberry Pi 4. All the info here about HW config is pretty straightforward but there is always a but and that is for me the firmware settings.
My printer is delta kossel powered by 24V 20A power supply with 240 mm heatbed and single v6 extruder. There are 3 temperature sensors:
Semite
by
jafido
-
Firmware - experimental, borrowed, and future