Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
@gloomyandy board.txt from wiki you recommended finally worked during random reboot. It did not work on few reboots and pi overheated.
When it succeeded I got following initial errors and warnings:
4/28/2020, 9:59:39 AM Warning: M307: Heater 0 appears to be over-powered. If left on at full power, its temperature is predicted to reach 365C
4/28/2020, 9:59:39 AM Error: M552: Networking is not
by
rudenick
-
Firmware - experimental, borrowed, and future
Yes, here it is:
=== Diagnostics ===
RepRapFirmware for LPC176x based Boards (biquskr_1.4) version 3.01-RC9+1 running on LPC176x at 120Mhz
Used output buffers: 1 of 16 (10 max)
=== RTOS ===
Static ram: 3760
Dynamic Memory (RTOS Heap 5): 3520 free, 3496 never used
Exception stack ram used: 200
Never used ram: 484
Tasks: HEAT(blocked,1484) MAIN(running,1768) IDLE(ready,84)
Owned mutexes:
=== Plat
by
rudenick
-
Firmware - experimental, borrowed, and future
I'm getting M122 ( in Duet web interface) through gpio pin connection with soldered R100 resistors. Gold ribbon on the resistor points towards SKR motherboard. USB cable is not connected.
More info, I'm using TMC2209 steppers in UART.
by
rudenick
-
Firmware - experimental, borrowed, and future
Hi!
I have trouble configuring SKR 1.4 Turbo. I tried rc 8 9 and 10. I have tried board.txt from wiki + files from either configurator or from the github repository. They both don't work for me but their weird combination at least lets me get M122 output. Other things still don't work.
I have Ender 3 Pro and raspberryPi 4B.
Here is the code that lets me M122. Further I pasted snapshot of code
by
rudenick
-
Firmware - experimental, borrowed, and future