Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Quotesdavi
Quotedarchap
; Z-Probe
M558 P4 C"Zmin" H5 F600 T6000 ; set Z probe type to switch and the dive height + speeds ALSO TRIED ZSTOP
G31 P500 X0 Y0 Z15.9 ; set Z probe trigger value, offset and trigger height
M557 R80 S20 ; define mesh grid
Note that my zprobe is not inverted. Ie if i config my x endstop as this M574 X2 S
by
darchap
-
Firmware - experimental, borrowed, and future
Quotejay_s
@darchap
The pin names got standardised a while back and can be found here.
Rather than C"5", use C"Zstop" or C"Zmin"
Yeah C"5" is what i had on my rrf2 config.g. for yor build i tried ZMin but didnt work, now i also tried Zstop but same thing.
This is my current config:
; Endstops
M574 X2 S1 P"!XMax" ; configure active-high endstop for high end on X via pi
by
darchap
-
Firmware - experimental, borrowed, and future
Hello, ive been using for a while rrf 2 port from sdavi on my delta with mks sbase 1.3
Yesterday i tried latest rrf 3 RC9 but i couldnt get mapped my zprobe (currently using a switch connected to zmin pin on rrf 2).
tried to map my zmin as an endstop to test if worked and it did. (also tried an endstop as my zprobe and didnt work)
Any ideas about how to configure it? everything else just worki
by
darchap
-
Firmware - experimental, borrowed, and future