Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 8 of 8
Ah yes, forgot that one completely. Thanks, seems to be working now. Haven't printed anything yet and my Raspi just hangs by the wires at the moment, but everything seems to work so far. And network speed is way up, from ~70kb/s to 5.5Mb/s so that's an nice improvement.
by
spegelius
-
Firmware - experimental, borrowed, and future
Trying to set up SBC mode with MKS Sbase, is it supported? I have Raspi set up and connected the boards using info from SKR instructions to correct pins in MKS. However, even though Duet Web Server and Duet Control Server are alive, browsing to keeps telling that DCS is not started.
by
spegelius
-
Firmware - experimental, borrowed, and future
The fix seems to work, the fan now starts when set to full speed, no need to set other speeds before that.
Also the layer artifacts are present with Marlin too, so nothing firmware related.
by
spegelius
-
Firmware - experimental, borrowed, and future
Great, thanks. I'll test it maybe tomorrow, currently doing some printing with Marlin to get some reference, I'm getting some wierd layer artifacts. Probably related to the abysmal part cooling, but I want to see if the problem manifests with Marlin too.
by
spegelius
-
Firmware - experimental, borrowed, and future
The fan is definitely working in a weird way and it doesn't seem to be about the fan as I tried with another fan and it shows the same behaviour. It seems that if the fan frequency is below 500Hz (tried 400Hz and below), issuing M106 S255 as the first command after boot or M950 doesn't start the fan. However, if the fan frequency is 500Hz or more, M106 S255 works as expected.
When frequency is 40
by
spegelius
-
Firmware - experimental, borrowed, and future
Loading times are fine, no excessive waits. File upload is a bit slow, about 90kB/s average so with bigger files it takes a while, but not a big problem.
Ok, good to know about the Wifi-module. I'll probably try the SBC route at some point, with raspi I could use a webcam. For now ethernet is fine.
by
spegelius
-
Firmware - experimental, borrowed, and future
Tried latest 3.1.1 version and it seems to work quite well. I have MKS SBase 1.3 and I'm using ethernet, at least for now. Might try SBC and Wifi later, although my ESP8266 doesn't have USB port so flashing it might be interesting (its MKS tft Wifi-module).
Couple of issues though:
- at first the board kept resetting itself and it was impossible to get connected with DWC. The board got an IP add
by
spegelius
-
Firmware - experimental, borrowed, and future