Hi Ludara, Just for comparisons sake, what are your settings in configuration.h for the following? #define INVERT_X_DIR false // for Mendel set to false, for Orca set to true #define INVERT_Y_DIR false // for Mendel set to true, for Orca set to false <--Thing to note for me is that I run a mendal and have to set this to "false", not true as noted in comment... #define INVERT_Z_DIR faby TobinatorCO - General Mendel Topics
Happy camper: My apologies for the long reply, hope it helps.... Regarding the variable: #define PROBE_SERVO_DEACTIVATION_DELAY 500 Maybe I misunderstood the description of how that timer value works, but this is what I understand: This timer defines how long to keep the server "active" and looking that the signal pin. By "active servo" I mean the controller circuit in the servo is looking aby TobinatorCO - General Mendel Topics
Lee-Seaw, Glad you got past that hurdle, but now you are facing the same problem I have. your Z axis sounds like it is moving down instead of up. If you have the same problem I have, if you perform a G28 X0, it will go back to working like normal, but you clear the grid determined by the G29 command. If you figure it out, please let me know because I too have the same issue.by TobinatorCO - General Mendel Topics
Lee-Saw, Based on your ""INVERT_(axis)_DIR" settings being all being set to "true", it is a little confusing to me which way is which. is your "home" position in the back right of the plate? But I would check check your position and offset settings. you have: #define X_PROBE_OFFSET_FROM_EXTRUDER 0 #define Y_PROBE_OFFSET_FROM_EXTRUDER -63 #define Z_PROBE_OFFSET_FROM_EXTRUDER -12. andby TobinatorCO - General Mendel Topics
thanks for the reply uncle_bob. To confirm what you mean by "temperature stable", I *think* you mean that the Servo will react differently (Degrees of movement when actuated or retracted) when it is at room temperature compared to when it is "heated" in proximity to the extruder head? I did notice some variation when I was first implementing, so I "cheated" and set "mechanical zero" to the "stby TobinatorCO - General Mendel Topics
Thanks everyone for their work on this feature. I have been pretty successful in getting this feature setup in regards to HW and config, but I also have been plagued by Z-axis reversed that results in the Extruder digging into the bed when I try to print. If I zero/Home X and Y it stops, but then the auto-level feature is not working (I suspect because G28 X0 command still defaults the measuredby TobinatorCO - General Mendel Topics