Guys I need some help here. For a long time I have used RAMPS on my Prusa I3 but I decided to make some upgrades, then I bought a RAMBo and installed it on my printer. The point is that I can't upload the firmware (Marlin), I have choosen the right board and followed a youtube tutorial. But It keeps showing this error: stepper.cpp:1534: error: 'DIGIPOT_MOTOR_CURRENT' was not declared in this scoby Carlos Fellip - Firmware - Marlin
I'm testing a glass plate over the MK3 Heatbed, it worked pretty well on my first test.by Carlos Fellip - General Mendel Topics
I already have a glass, but may i use it over a MK3 heatbed? If yes, which size of binder clip shoud i use because the binders i used with mk2+glass looks too small. But i still think that MK3+Glass+y carriage would get too heavy wouldn't it?by Carlos Fellip - General Mendel Topics
Good day. Some months ago i bought my first 3D printer (a Prusa i3 kit), since then i have done some awesome prints on PLA. But as the heatbed could reach only 65ÂșC I was unable to print on ABS. Then i bought an Alu-Heatbed MK3 for printing on ABS and because it heats up faster than the MK2. But there is a hole in the center so how can I print? Do i have to fill that hole? With what? I'm not suppby Carlos Fellip - General Mendel Topics
Thank you Kurzaa! I found the test code, the firmware (i downloaded Marlin) and the Repieter Host. I will try this out and send an e-mail for the provider of my kit too.by Carlos Fellip - Firmware - mainstream and related support
Thank you guys! Just another question, have you used conductive paste to ensure that the thermistor temperature will be the same of the glass?by Carlos Fellip - General Mendel Topics
Hi people i'm new on the forum. I have just finished the mechanical and wiring guide of my Czar Prusa i3 guide. But there is no information about how to glue the thermistor on the heatbed. May you help me with a brief explanation of that? Regards Carlos Fellipby Carlos Fellip - General Mendel Topics
Hi people I'm new in the forum and 3D printing "world". I have just finished building the mechanical part and wiring of my Prusa i3 kit. But i have no ideia of which softwares I should install. Also i don't know which sketch i have to upload on Arduino MEGA. May be you could help me giving some guideline (I didn't found any tutorial of how to use the 3D printer for the first time).... Regards Carby Carlos Fellip - Firmware - mainstream and related support