Quoteludara edn: Thank you very much for your time and knowledge! I did what you instructed me to do and after a G29 here you have what Pronterface returned: SENDING:G29 Bed G29.1: X:45.0000000 Y:10.0000000 Z:1.7938970 Bed G29.2: X:45.0000000 Y:400.0000000 Z:3.0104327 Bed G29.3: X:445.0000000 Y:400.0000000 Z:2.5990529 Bed level matrix: 0.9999996 0.0000000 -0.0010284 0.0000000 0.9999951 0.00by edn - General Mendel Topics
Quoteludara Hi again, New arduino, new ramps, new switch, the problem still exists. What can I do now??? Thanks This problem is showing up in too many people's setup. I suspect there is a logic flaw that the community is going to have to work through. I think the most likely explaination is the correction matrix has it's normal pointing in the wrong direction. Do you have the 3 point proby edn - General Mendel Topics
Quoteludara Hi again, folks: Today I reconnect my endstop switch completely, making sure that there were no problems with the wiring or false contacts and my problem persists, after a G29, my Z axis is still being reversed so I cant send a piece to the printer because my bed will try to go up instead of down..... I am very confused, can you please help me further?? Thanks in advance!! Your asby edn - General Mendel Topics
Quoteregpye Quoteedn Yes, I have the Marlin code ported to the PrintrBoard with Auto-Bed Leveling working... I do have some issues but getting close to getting them resolved. . Can you please share how you connected the servo to the Prinrboard? Here you go. This is my current Marlin PrintrBoard build environment. I have a couple of comments for you. - My Z-Axis probe is on the front oby edn - General Mendel Topics
Quoteregpye Seems very strange. Not only is it lifting the probe between sensing, it is also probing in all four corners while everyone else probes in three corners only. How about showing us the start of your G-code so we can see what it is suppose to be doing? The 'ACCURATE_BED_LEVELING' code that is now merged back into the main branch of the tree does this. It probes an n x n grid. And iby edn - General Mendel Topics
I have Auto_Bed_Leveling working on the PrintrBoard. (I do have some issues but I'm working through them). What I've got is this code in the PINS.H file for motherboard type 81: #ifdef NUM_SERVOS #define SERVO0_PIN 11 #define Z_MIN_PIN 30 //needs to be updated to what ever wire is used. That logical pin is the corner pin on the Expansion-2 Header that is closest to the maby edn - General Mendel Topics
Yes, I have the Marlin code ported to the PrintrBoard with Auto-Bed Leveling working... I do have some issues but getting close to getting them resolved. Right now I'm debugging the 'ACCURATE_BED_LEVELING' with: #define ACCURATE_BED_LEVELING_POINTS 5 This is a little bit excessive but it is needed for the debugging I'm doing. In the G29 command I've added code to display the probed posby edn - General Mendel Topics