Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 6 of 6
I fixed everything... But, I changed so many things I couldn't tell you what exactly fixed the compiling. I found a post somewhere in the Skienforge forum that had someones default settings. I just put them all in. There are a multitude of settings in skeinforge. My problem was one of the many settings in there. In Pronterface I opened the settings option and waded in. In the Preface "tab"
by
dbarbe
-
Sanguino(lolu)
OK, I've looked everywhere, what setting would make skeinforge retract an inch or more of filament at the start of a print? I can't see or understand what in the g-code would cause this. Anyone have an idea as to what setting might cause this?
by
dbarbe
-
Skeinforge
Thanks, Traumflug. There are no extruder commands at the end of the g-code lines. So, after reading more, I guess my problem is a setting in skeinforge. I should be asking questions in the skeinforge forum now. Thanks again.
by
dbarbe
-
Sanguino(lolu)
I didn't think of that! I suspect you are correct, as the extruder responds when such commands are manually entered on the command line. But, if it isn't there, what do I do about it?
by
dbarbe
-
Sanguino(lolu)
I'm starting up a Prusa Mendel I bought as a kit. The Sanguinololu board was preloaded when I got it. Each axis works correctly, the extruder works when clicking on the "Extrude" and "Reverse" buttons on the Pronterface graphic interface. However, when I load a file, the X,Y and Z axis work, the head traces out each layer correctly, but the extruder does nothing. The temperature reports at 205
by
dbarbe
-
Sanguino(lolu)