Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Hi,
I am buying a new power supply for my I3 and a lot of the newer ones have a much larger 120mm fan on the side of the PSU.
Example :
SO if I mount this inside my I3 box, is it bad to have the fan pointed at the build plate? would that cause uneven cooling and warping?
it seems like there is no other good way to mount the power supply. Even if I bought a power supply without a huge 120m
by
jordananders3
-
Printing
I have the opposite issue. Nozzle drags on the first 3 layers but is fine on the last three.But I'm using slicer.
by
jordananders3
-
Skeinforge
Thank you Thank You Thank you!
I updated slicer,
changed the nozzle temp from 117 to 130, and it printed like a charm.
Oh yea and I am printing in red ABS from Kbell engineering.
I did have to leave my heatbed on the whole time, otherwise the large wade's gear warps itself off of the print bed.
For the small gear, I ran the meachine at 100% speed for the lockscrew holder part, then turned it d
by
jordananders3
-
Printing
Thanks ralf. I will try what you suggested tomorrow. I'm a little bit weary about bringing my nozzle temperature to 240 degrees because it is a Chinese J head but I will see what I can do. I will report back soon.
by
jordananders3
-
Printing
So whenever I print a larger object (ramps box, or wade extruder size), about 10 or so layers into the print, it starts printing a huge perimiter, larger than what I set, and it ends up warping and ruining the rest of the print. I have slicer set to print at least 3 perimiters, but this one is about 9 or so layers wide.
Sorry if this is a noob question, because this is my first 3d Printer. Her
by
jordananders3
-
Printing