Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
E.: I'm tried again with the version you just posted, 2009-11-03 and had the same problem. Attached are my settings, I'm using "rapman ABS".
thx,
--jet
by
jet
-
Skeinforge
I'm having problems on OSX 10.5.8 with a build I downloaded earlier today. Not only does it crash on most of my very simple models, it hangs with a blank screen on one of the supplied models (see below).
Any suggestions on where to start looking? I'm going to assume it's a problem with the default python install.
$ ./skeinforge.py models/Screw\ Holder\ Bottom.stl
File models/Screw Holder Bot
by
jet
-
Skeinforge
I just built mine, and other than reversing the power/debug LEDs, I don't think I screwed anything up. But on the Mac, I'm having the same connection problem and no blinking LEDs after I press reset.
So this:
>If it doesn't flash you may have gotten a blank CPU that hasn't been flashed >yet.
Just means I need to bootload it, right?
by
jet
-
Controllers
