Show all posts by user
Page 5 of 5
Pages: 12345
Results 121 — 122 of 122
My Mendel90 is printing quite nicely now but since changing to Marlin firmware a few days ago I have noticed significant warping at sharp corners of the base of angular prints. The print is generally sticking well to the glass and I am now wondering if this is an acceleration/jerk issue.
I like the way that Marlin speeds the nozzle around smooth curves. I don't like the way it is pulling the fil
by
richgain
-
General
Have you watched nophead's video?
I wish I had seen this before I wired my Huxley. I ended up leaving some of the the wires too long and then soldered them as well with the result that the pins wouldn't go right to of the end of the socket.
I made the Mendel90 after watching this video and all the crimps went smoothly, much stronger than before and no need for soldering at all.
by
richgain
-
Reprappers
Page 5 of 5
Pages: 12345