Thanks for that I have got the the gen7 in the right place and it has compiled sprinter. But now find the two chip I have will not program and I need too erase the chip! I have down loaded the 1284p data sheet and going to make parallel chip programmer, hope this fixes the problem.by alan-oz - Sanguino(lolu)
Hi Have upgraded to Arduino 1.0.5 the 1284 board does not show up in board list I have tried to installing gen 7 v2.1, it still does not show in boards. I place gen 7 in hardware folder is that still right.by alan-oz - Sanguino(lolu)
Hi I have put together a Prusa Mendel Printer, it has a Sanguinololu board, the kit came from Amozn. All it does when it is powered is to move the x and y motor a few steps in each direction and back again. So the board must have a boot loader! and some sort of a program. I have a new Atmega chip and a Arduino uno. I have arduino 1.01 version and have added gen7 to it. I am using the Arduino withby alan-oz - Sanguino(lolu)
Hi I have put together a Prusa Mendel Printer, it has a Sanginololu board, the kit came from Amozn. All it does when it is powered is to move the x and y motor a few steps in each direction and back again. So the board must have a boot loader! and some sort of a program. I have a new Atmega chip and a Arduino uno. I have arduino 1.01 version and have added gen7 to it. I am using the Arduino withby alan-oz - Sanguino(lolu)