Show all posts by user
p.s. RepRap.org isn't responsible for scams and bad deals.
Need J-Head Mount made. - 13 years ago
Hi I bought a J head MK V to replace my old broken hot end. I had thought I would have access to anougther printer to make the mount, but unfortuantely no. A link to the file on thingiverse. Need the mount with the cable holder (2ed stl from bottom) and the spacer/filling printed. I live in Iowa so preferably someone around that area to keep shiping low. A speedy responce would be appreciateby Ryan on Mars - Job Shop: I need stuff made!
New Mega 2560 - failed to leave programming mode - 13 years ago
Just unwrapped my new mega 2560, loaded the latest arduino IDE, selected the Blink sketch, changed the Board to Arudino Mega 2560 and selected the right serial port. When I try downloading the example Blink sketch I get the following errors (and the sketch doesn't run): avrdude: stk500v2_command(): unknown status 0xc8 avrdude: initialization failed, rc=-1 Double check connections and try again,by Ryan on Mars - Controllers
Unable to upload Sprinter to RAMPS 1.4 - 13 years ago
Hi I can't seem to get the upload to work to my ATMega2560. I have version 0023 of the arduino environment. I have a brand new USB cable. I have tried uploading Marlin, failed, switched to sprinter because someone told it was easier, failed again. Not even the RAMPS test code will upload. All my Baum settings are the same. Have tried 250000 and the one below that. Made sure I had the right boardby Ryan on Mars - Firmware - mainstream and related support
Re: Large Format Printer - 13 years ago
Why not just print the molds directly? BAM!by Ryan on Mars - Wanted
Re: Largest single volume print I've seen from Prusa Mendel - 13 years ago
I wonder if you attached some sort of heating element like a mini hair dryer to each of the four corners if you could prevent the warping and crack.by Ryan on Mars - Look what I made!